Product ID:POLYESTER POWDER COATING, TGIC SERIES
MSDS Date:04/15/1996
FSC:8010
NIIN:00N077982
MSDS Number: CDZSG

CARDINAL INDUSTRIAL FINISHES

1329 POTRERO AVE
SOUTH EL MONTE, CA 91733
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 818-444-9274

Preparer: RICHARD A STEWART

Cage: 65860

CARDINAL INDUSTRIAL FINISHES

SOUTH EL MONTE, CA 91733 US

Telephone: 818-444-9274 OR 213-283-9335

Cage: 65860

0.0 @ 20C

CAS: 1333-86-4

RTECS: FF5800000

Fraction By Weight: 0-5%

OSHA PEL 3.5 MG/M3

ACGIH TLV: 3.5 MG/M3

0.0 @ 20C (MFR INVALID

CAS: 2451-62-9

RTECS: XZ1994900

Fraction By Weight: 0-10%

OSHA PEL N/K

ACGIH TLV: N/K

0.0 @ 20C

CAS: 105-60-2

RTECS: CM3675000

Fraction By Weight: 0-5%

OSHA PEL N/K

ACGIH TLV: N/K

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

0.0 @ 20C

CAS: 7727-43-7

RTECS: CR0600000

Fraction By Weight: 0-25%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

CONTROLS SHOULD BE IMPLEMENTED TO REDUCE

RTECS: 9999999ZZ

PREVENT REPEATED/PROLONGED SKIN CONT W/GB

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE: EYES: CAN CAUSE IRRITATION AND
REDNESS, TEARING OR BLURRED VISION. SKIN: IRRITATION, RASH AND
DERMATITIS POSSIBLE FROM PROLONGED EXPOSURE. INHALATION: COUGHING,
SNEEZING, NASAL IRRITATION, HEAD ACHE, DIZZINESS, NAUSEA, WEAKNESS.
Explanation of Carcinogenicity:CARBON BLACK: IARC MONO ON EVAL OF
CARCIN RISK OF CHEMICALS TO MAN, VOL 65, PG 24-27, 1995: GROUP 2B.
ANIMAL: LUNG.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PREEXISTING RESPIRATORY CONDITIONS,
PREEXISTING SKIN DISORDERS.

First Aid:EYES: FLUSH WITH WATER FOR AT LEAST 15 MINUTES. GET MEDICAL
ATTENTION IMMEDIATELY SKIN: WASH EXPOSED AREA WITH SOAP AND WATER.
REMOVE CONTAMINATED CLOTHING. INHALATION: REMOVE TO FRESH AIR. IF
BREATHI NG IS DIFFICULT, ADMINISTER OXYGEN. IF BREATHING HAS
STOPPED, GIVE ARTIFICIAL RESPIRATION. GET MEDICAL ATTENTION.
INGESTION: INDUCE VOMITING. KEEP PERSON WARM AND QUIET. GET MEDICAL
ATTENTION.

Extinguishing Media:FOAM, DRY CHEMICAL, CARBON DIOXIDE, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:WHEN EXPOSED TO EXTREME HEAT, DECOMP
PRODS MAY YIELD OXIDES OF CARBON & NITROGEN/TOX FUMES. NOTE: THIS
PROD IS A DRY POWDER & UNDER NORM OPERATING (SUP DAT)

Spill Release Procedures:REFER TO OTHER SECTIONS OF THIS MSDS.
ELIMINATE ALL IGNITION SOURCES. SWEEP UP SPILLS AND PLACE IN DRUM
OR OTHER SEALABLE CONTAINER. AVOID GENERATING DUST FROM CLEAN UP
MATERIAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN COOL, DRY PLACE & PROTECT
FROM BREAKAGE. AVOID STORING AT TEMPS > 80F. AVOID EXCESS
MOISTURE/EXTREME HEAT.
Other Precautions:DO NOT ALLOW POWDER DUST TO ACCUM NEAR
MACHINERY/SOURCES OF IGNIT. POWDER COATINGS SHOULD BE APPLIED ONLY
W/PROPER APPLICATION EQUIP W/IN PROPERLY VENTD CTL ENCLOSURE.
POWDER COATING EQUIP SHOULD BE G ROUNDED AT ALL TIMES TO PVNT (SUP
DAT)

Respiratory Protection:IF TLV OF PROD/ANY COMPONENT IS EXCEEDED, NIOSH
APPRVD AIR SUPP RESP IS ADVISED IN ABSENCE OF ENVIRON CTL. OSHA
REGS ALSO PERMIT OTHER NIOSH RESP UNDER SPECIFIED CNDTNS (SEE YOUR
SFTY EQUIP SUPPLIER). ENGINEERING/ADMINISTRATIVE (ING 5)
Ventilation:PROVIDE SUFFICIENT MECH (GENERAL AND/OR LOCAL EXHAUST) VENT
TO CONTROL DUST ACCUMULATION & MAINTAIN EXPOS BELOW TLV.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EMERGENCY EYEWASH & DELUGE
SHOWER . HAND CREAM SUGGESTED FOR MANUAL SPRAY EQUIP. (ING 6)
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING RESTROOM.
SMOKE IN SMOKING AREAS ONLY.
Supplemental Safety and Health
EXPLO HAZ: CNDTNS PRESENTS MIN RISK OF FIRE/EXPLO. HOWEVER, PROPER STOR
& CAUTION IN HNDLG & USE PRACTICES SHOULD BE USED AT ALL TIMES.
OTHER PREC: STATIC ELEC BUILD-UP (OSHA 29 CFR 1910.107). NO OPEN
FLAMES/SOURCES OF IGNIT/SPK PRODUCING EQUIP SHALL BE LOCATED W/IN
20 FEET OR POWDER USE, UNLESS SEPARATED BY PARTITION.

Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:1.2-1.8
Appearance and Odor:POWDER OF VARIOUS COLORS
Percent Volatiles by Volume:<2

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.
Stability Condition to Avoid:EXTREME TEMPERATURES.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

Waste Disposal Methods:REUSE OR RECYCLE WHENEVER POSSIBLE. DESTROY
WASTE SOLIDS BY INCINERATION, OR DISPOSE OF IN AN APPROVED LANDFILL
IN ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.